What would you suggest for better absorption? Is adding ethanol enough?
DMSO and microneedling.
What would you suggest for better absorption? Is adding ethanol enough?
I’ve mixed up the topical as per instructions, how much do you use when applying? And how do you measure? minoxidil dropper?
I normally use a minoxidil dropper and just cover my scalp really, no specific measurements.
Just to double check by "mixed up the topical", hopefully you didn't just mix the four together and give it a shake? Sandalore is insoluble in water so if you mixed all four together at once it most likely produced a precipitate and became ineffective
You have to mix the ethanol with the sandalore, leave for 48 hours (shake multiple times a day during the 48h) then add PG and distilled water.
I followed this guide/experiment here: https://www.reddit.com/r/tressless/comments/9rbf7b/sandalore_a_scientific_homemade_approch/
The amounts on that page confuse me, I was using the formula in this thread. 20 Eth 20 water 10 PG 5ml Sandlore
According to the study using 10% could have a reverse effect.
I think those instructions are just to sell more product. 4ml of that is going to run right off the top of your head. I use 1-2ml
Maybe. On the other hand, the product contains up to 4% stemoxydine, according to Amazon seller. Plus I'm Norwood 6, so less than 4ml I'm not sure it will be effective.
https://pellwall.com/sandalore-baldness/Where do you buy the active agent? I used essential oil but it didn't do sh*t.